Bode analyser - DC/DC Converter Stability Measurement

Just about everything about Red Pitaya
Post Reply
trimen
Posts: 1
Joined: Fri Jul 03, 2020 1:23 pm

Bode analyser - DC/DC Converter Stability Measurement

Post by trimen » Fri Jul 03, 2020 1:56 pm

Hello,

I'm trying to do some power supply stability measurement with RP and I can't get satisfying results.

I'm trying to measure a cheap DC/DC converter with LM2596. I basically follow the Bode100 app note. As an injection transformer, I used a 3VA transformer with two separate 9V secondary windings. One is connected to the output of RP (DC resistance ~25Ohm) and another is connected to 10Ohm resistor in the feedback loop.

https://www.omicron-lab.com/fileadmin/a ... y_V3_3.pdf

However, the measurement is somewhat distorted and the output is not expected.
I wasn't able to find more information on this subject with RP integration.
Is it possible to get more information on how to correctly use RP in this case?
Also, the measurement is relatively slow.
You do not have the required permissions to view the files attached to this post.

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 2 guests