Signal acquisition after reboot

Just about everything about Red Pitaya
Post Reply
Posts: 1
Joined: Mon Sep 14, 2020 1:46 pm

Signal acquisition after reboot

Post by pedram » Mon Sep 14, 2020 2:02 pm

I have been using a STEM 125-14 v1.0 signal acquisition through SCPI command.
An issue that I have is that I receive completely wrong signal (sometimes) after rebooting the Redpitaya. In those cases repeated signal sampling gives incorrect signal. After doing a second or third reboot, things start to work as they should. Has anyone seen a similar issue?

Something that I noticed is that when I look at the signal with the oscilloscope application I see the correct signal amplitude but when I use ACQ:SOUR1:DATA? the signal amplitude is about 20 times lower than what it actually is.

Thanks in advance,


Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 2 guests