Hello,
I am currently working on a Red Pitaya application for which I would like to build my custom Petalinux project on a StemLab 125-10 board. To this end, I need detailed information on how to configure the Zynq PS and the DDR configuration parameters.
Unfortunately, the Zynq PS configuration available in the official Git repository (https://github.com/RedPitaya/RedPitaya/ ... temZ10.tcl) only applies to the StemLab 125-14 board, which uses the 4Gb DDR (MT41J256M16 RE-125).
What Zynq PS configuration and DDR part number should I use for the StemLab 125-10 board?
Thank you for your help and best regards
Paul
DDR parameters for Petalinux on StemLab 125-10
-
- Posts: 1
- Joined: Sat Mar 05, 2022 11:00 am
Re: DDR parameters for Petalinux on StemLab 125-10
I have just run into the same issue. Unfortunately, the schematics are not helpful in that regard. Please advice.
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 11 guests