Adding another high speed ADC

Just about everything about Red Pitaya
Post Reply
elevon
Posts: 1
Joined: Mon Jan 25, 2021 1:09 am

Adding another high speed ADC

Post by elevon » Mon Jan 25, 2021 1:55 am

Hi!

I would like to make a small shield to add another LTC2145.

But there are only 16 digital I/O pins on the board. Fortunately the A/D chips can operate in a double data rate mode.
Each data I/O pin would then update its value up to 250 times per second in single ended mode.
Would that rate still be acceptable for the extension connector pins?

Also, the schematic states that those are 3.3 V pins.
The high from the data pins of the ADC will be 1.8 V. Is this high enough to be detected as such by the I/O-pin?

Thank you!

User avatar
redpitaya
Site Admin
Posts: 876
Joined: Wed Mar 26, 2014 7:04 pm

Re: Adding another high speed ADC

Post by redpitaya » Thu Mar 18, 2021 10:27 am

1.8V - probably should not work.

under 0.8V is a low and over 2V is a high according to our documentation
https://redpitaya.readthedocs.io/en/lat ... 20analizer

But you can try it if you can.

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 1 guest