Adding another high speed ADC
Posted: Mon Jan 25, 2021 1:55 am
Hi!
I would like to make a small shield to add another LTC2145.
But there are only 16 digital I/O pins on the board. Fortunately the A/D chips can operate in a double data rate mode.
Each data I/O pin would then update its value up to 250 times per second in single ended mode.
Would that rate still be acceptable for the extension connector pins?
Also, the schematic states that those are 3.3 V pins.
The high from the data pins of the ADC will be 1.8 V. Is this high enough to be detected as such by the I/O-pin?
Thank you!
I would like to make a small shield to add another LTC2145.
But there are only 16 digital I/O pins on the board. Fortunately the A/D chips can operate in a double data rate mode.
Each data I/O pin would then update its value up to 250 times per second in single ended mode.
Would that rate still be acceptable for the extension connector pins?
Also, the schematic states that those are 3.3 V pins.
The high from the data pins of the ADC will be 1.8 V. Is this high enough to be detected as such by the I/O-pin?
Thank you!