Hi,
I'm trying to calibrate my RP but since I don't have a 0.5V reference available and I never use the LV range, I was wondering if it is possible to only calibrate the HV range.
I tried with the manual calibration but I can't get to something usable and am not sure of doing it right.
Does anybody know how to use the manual calibration procedure?
Manual calibration
-
redpitaya
- Site Admin
- Posts: 667
- Joined: Wed Mar 26, 2014 7:04 pm
Re: Manual calibration
Hey,
Sorry for the late reply.
You can use some sort of a resistor divider to achive the wanted voltage (0.5 Volts) if you have a higher voltage source. That could solve your problem.
The calibration currently does not support calibration for only one voltage range.
Sorry for the late reply.
You can use some sort of a resistor divider to achive the wanted voltage (0.5 Volts) if you have a higher voltage source. That could solve your problem.
The calibration currently does not support calibration for only one voltage range.
-
nuyte
- Posts: 1
- Joined: Wed Dec 21, 2022 10:04 pm
- Location: Australia
- Contact:
Re: Manual calibration
Hi,
If you are trying to calibrate your RP but since you don't have a 0.5V reference available and you never use the LV range, yes you can calibrate the HV range. And I believe it is correct.
Thanks! I usually work on furniture.
If you are trying to calibrate your RP but since you don't have a 0.5V reference available and you never use the LV range, yes you can calibrate the HV range. And I believe it is correct.
Thanks! I usually work on furniture.
Last edited by nuyte on Sat Dec 31, 2022 4:39 pm, edited 1 time in total.
-
redpitaya
- Site Admin
- Posts: 667
- Joined: Wed Mar 26, 2014 7:04 pm
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 1 guest