Problems with DHCP connection

Just about everything about Red Pitaya
Post Reply
Posts: 1
Joined: Thu Jul 30, 2015 8:49 am

Problems with DHCP connection

Post by arkahalder23 » Fri Jul 31, 2015 9:12 am

Working on Windows 7, I followed the instructions for connecting to the Red Pitaya using DHCP configuration as given below :
But the above failed (stating IP address conflict) and thus I proceeded to the Manual network interface configuration instructions also given in the wiki user manual, yet again bearing no result.
We proceeded to do so because the apparently easier method of the local network connection isn't always working! Sometime it works fine, some other times the same fails to connect.
Would like to listen to your opinions on the above.

Nils Roos
Posts: 1441
Joined: Sat Jun 07, 2014 12:49 pm
Location: Königswinter

Re: Problems with DHCP connection

Post by Nils Roos » Wed Aug 05, 2015 12:24 pm

The instructions you linked describe static IP configuration for your computer and are meant for a point-to-point connection between your computer and the RP, or for networks with no DHCP.
If your network provides a DHCP server - like most modern routers do - you should avoid arbitrary static addresses. If you do use them, you need to tell the DHCP server which addresses you'd like to assign statically, to avoid conflicts.

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 1 guest