No IP with direct cable connectios

[ignacio.horcas]

Hello,

I am new with Red Pitaya. I followed the installation instructions and was unable to connect to 192.168.1.101.

Connecting the USB cable an typing ifconfig it seems eth0 has no IP address:

eth0 Link encap:Ethernet HWaddr 00:26:32:f0:1a:15
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:95 errors:0 dropped:0 overruns:0 frame:0
TX packets:5 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:11034 (10.7 KiB) TX bytes:1710 (1.6 KiB)
Interrupt:54 Base address:0xb000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)

I am using a cable to connect my Red Pitaya to my computer and leds in the ethernet connector look OK (green on and yellow blinking). The lled in the board also look correct.

Any suggestion?

Thank you very much.

[pavel]

You can try the fix that I proposed in another thread:

viewtopic.php?t=568&p=2672#p2672