RF Output - Gibbs phenomenon ?

Placement, modules, components and accessories; the ones that exist and the the nice-to-be's
Post Reply
pmrp
Posts: 1
Joined: Thu Jun 10, 2021 8:57 am

RF Output - Gibbs phenomenon ?

Post by pmrp » Thu Jun 10, 2021 9:30 am

Hello Red Pitaya community !

I am just beginning to play with this wonderful tool (RP 125-14), mostly with basic RF signal generation & acquisition.

My project involve sending pulse-echo signals for ultrasound NDT applications. However, while playing with the oscilloscope app to generate 1us pulses (using 1kHz PWM with 0.1% duty cycle), I noticed a very high amplitude oscillations with a central frequency around 20MHz (see the screenshot below).

The setup is very simple: the OUT1 is directly plugged to the IN1 via a BNC cable & adaptors. All other inputs/ouputs are isolated with 50ohm terminators. Swapping between inputs and outputs does not change anything in the result.

Is it the usual behavior ? I would not expect the Gibbs phenomenon to be that strong, given the bandwidth of the RP's outputs. Would that come from the impedance of the BNC cable or something else ?

Image

Thank you by advance !

kasaudio
Posts: 49
Joined: Sun Mar 11, 2018 6:03 pm

Re: RF Output - Gibbs phenomenon ?

Post by kasaudio » Thu Jun 17, 2021 1:02 pm

Hello.

Is out1 also 50 ohm terminated?

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 2 guests