Is it possible to configure the ADC to be uni-polar?
Posted: Wed Jan 04, 2017 5:13 am
Hi all,
I am curious whether it is possible to reconfigure the ADC on the board to be uni-polar, so it uses, say, 0-1V as the full range instead of +-1V. If so, does it require any soldering? Or can I make some changes in the constraint file to reconnect some pins to make this happen?
Thank you,
Jialun
I am curious whether it is possible to reconfigure the ADC on the board to be uni-polar, so it uses, say, 0-1V as the full range instead of +-1V. If so, does it require any soldering? Or can I make some changes in the constraint file to reconnect some pins to make this happen?
Thank you,
Jialun