LCR Meter specifications and control

Placement, modules, components and accessories; the ones that exist and the the nice-to-be's
Post Reply
Posts: 5
Joined: Wed Nov 02, 2016 2:44 am

LCR Meter specifications and control

Post by arlederman89 » Thu Jun 01, 2017 8:32 pm


I am relatively new to all things electrical engineering, so bear with me, please! I am working towards taking impedance measurements of a piezoceramic using Red Pitaya and the LCR meter extension module. I understand how to use the hardware, but I am curious if there is a block diagram type schematic like the one here: ... /shem.html for the main board to see how the LCR meter hardware works.

Also, does the LCR meter make measurements using the automatic balance bridge method? As a two-, five-, or four-terminal method?

I'm also not sure how to connect IN1 to ground. Can I simply use an alligator clip on the SMA connection and attach to a power supply ground port?

Finally, are there SCPI commands to remote control the LCR meter and impedance analyzer? I cannot seem to find them in the documentation, and the LCR meter script I did find looks like it works in the PC's command line.

Thank you for any help!


EDITS: I was able to figure out that it is a 2T auto-balancing bridge method device and how to use MATLAB to use the command line to run the lcr program. I would still be interested in a schematic of the extension board and more information about grounding the IN1 terminal.

Posts: 12
Joined: Mon Feb 13, 2017 10:18 am

Re: LCR Meter specifications and control

Post by mnordgard » Wed Sep 06, 2017 4:47 pm


How did you figure out that it was a 2T autobalancing bridge method? Is it documented anywhere? I cant find it myself.

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 2 guests