Page 1 of 1

Remove R43 to have a single-ended clock output

Posted: Mon May 28, 2018 9:07 am
by 8lu3
Hi,
I want to feed a clock out of the RedPitaya via the sata connector S1 connector. The two clock pins of S1 are connected by a 100Ohms resistor (for differential clock output). However, since I want to have a single-ended output I would like to remove this resistor (R43 in the schematics). Unfortunately, it isn't depicted in the schematics file. Does anyone got an idea how to find it?

Re: Remove R43 to have a single-ended clock output

Posted: Tue Jun 05, 2018 1:54 pm
by redpitaya
Hi,
it is on the bottom side of the board - see attached photo.
kind regards, Red Pitaya team