122.8-16 Stemlab won't start with sdr_hpsdr image
Posted: Mon Jun 17, 2019 5:11 pm
I just received my 50-ohm 122.8-16 Stemlab, which I want to use on the Reverse Beacon Network as a multi-band receiver. However, I'm having problems, and am looking for some insight.
First, I loaded Pavel Demin's image file from April 11, copied start.sh from sdr_receiver_hpsdr to the root, and powered it up. The green LED came on, and the yellow one at the left end of the row began blinking, like the red heartbeat used to with the Ubuntu version. However, there was no indication that it was running and on my network (no IP addresses - I'm told there should be 2).
Then I noticed that there was a later version of Demin's image, dated 5/27, so I loaded that instead. This time, when I powered the RP up, all I saw was the single green LED. No blinking yellow, and again, no indication (IP addresses, etc.) that the unit was actually running.
I'd welcome any suggestions about how to proceed with trouble-shooting.
First, I loaded Pavel Demin's image file from April 11, copied start.sh from sdr_receiver_hpsdr to the root, and powered it up. The green LED came on, and the yellow one at the left end of the row began blinking, like the red heartbeat used to with the Ubuntu version. However, there was no indication that it was running and on my network (no IP addresses - I'm told there should be 2).
Then I noticed that there was a later version of Demin's image, dated 5/27, so I loaded that instead. This time, when I powered the RP up, all I saw was the single green LED. No blinking yellow, and again, no indication (IP addresses, etc.) that the unit was actually running.
I'd welcome any suggestions about how to proceed with trouble-shooting.