Red Pitaya STEM 125-10: FPGA programming with JTAG
Posted: Wed Oct 02, 2019 1:16 pm
Good afternoon,
Before buying the Pitaya Red STEM 125-10, I would like to know if it is possible to use a JTAG to program only the FPGA. I have seen that the board does not have the 6-pin header where the JTAG should be connected. Can you solder it and would it work correctly?
Thank you very much for your attention.
Joaquim
Before buying the Pitaya Red STEM 125-10, I would like to know if it is possible to use a JTAG to program only the FPGA. I have seen that the board does not have the 6-pin header where the JTAG should be connected. Can you solder it and would it work correctly?
Thank you very much for your attention.
Joaquim