max Input Voltage on LV
Posted: Thu Mar 05, 2020 2:23 pm
Hello RP-Community,
I am a Electronics Student an i am working on a laboratory experiment. I read the manual and im a little bit unsure of the Voltage ratings. So the manual say the max Voltage 30v, but is this rating for booth stages(LV,HV) of the input? Because in this experiment the max voltage before switching is max 200 VDC and after switching only round about +-200mV. For the first Experiments we use an 10:1 Probe and the HV Stage. But the resolution of the +- 200mV is very low, so we come up with the idea to use the LV-Stage because of the better resolution in the low voltage area and we are now unsure because at 200V the input gets 20V. May this broke the LV-Stage, i read in one post that the 30V max rating is only for a short-run.
Thank you in anticipation!
Greetings Julian
I am a Electronics Student an i am working on a laboratory experiment. I read the manual and im a little bit unsure of the Voltage ratings. So the manual say the max Voltage 30v, but is this rating for booth stages(LV,HV) of the input? Because in this experiment the max voltage before switching is max 200 VDC and after switching only round about +-200mV. For the first Experiments we use an 10:1 Probe and the HV Stage. But the resolution of the +- 200mV is very low, so we come up with the idea to use the LV-Stage because of the better resolution in the low voltage area and we are now unsure because at 200V the input gets 20V. May this broke the LV-Stage, i read in one post that the 30V max rating is only for a short-run.
Thank you in anticipation!
Greetings Julian