Increase RF-output to +/- 5V

Placement, modules, components and accessories; the ones that exist and the the nice-to-be's
Post Reply
ThirdClassToaster
Posts: 3
Joined: Tue Jul 14, 2020 9:45 am

Increase RF-output to +/- 5V

Post by ThirdClassToaster » Tue Jul 14, 2020 10:29 am

Hello, I have the following question.

Is it possible to increase the output voltage of the RF outputs of the STEMlab board (e.g. STEMlab 125-14) from +/-1V (2V peak-to-peak) to +/-5V (10V peak-to-peak) by software ?
If not, would there be a circuitry measure that could be connected directly to the output to achieve this goal, e.g. a suitable amplifier add-on board that also has RF inputs and outputs with suitable SMA sockets ?

I need a symmetrical output voltage of +/-5V (full AC no DC) to supply an amplifier output stage, which amplifies the low-frequency measurement signal to the actual level of +/-40V.

Friendly greetings.

AbdelmoumenBacetti
Posts: 4
Joined: Thu Aug 06, 2020 3:30 pm

Re: Increase RF-output to +/- 5V

Post by AbdelmoumenBacetti » Sat Dec 19, 2020 7:50 pm

Hi ThirdClassToaster

Go to Minicircuits.com, you will find affordable and high quality amplifiers. They also have 50ohm transformers if you are using 10/12/14 version of RP.

https://www.minicircuits.com/WebStore/d ... HA-13LN%2B
https://www.minicircuits.com/WebStore/d ... DT16-6T%2B

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 21 guests