Increase RF-output to +/- 5V
Posted: Tue Jul 14, 2020 10:29 am
Hello, I have the following question.
Is it possible to increase the output voltage of the RF outputs of the STEMlab board (e.g. STEMlab 125-14) from +/-1V (2V peak-to-peak) to +/-5V (10V peak-to-peak) by software ?
If not, would there be a circuitry measure that could be connected directly to the output to achieve this goal, e.g. a suitable amplifier add-on board that also has RF inputs and outputs with suitable SMA sockets ?
I need a symmetrical output voltage of +/-5V (full AC no DC) to supply an amplifier output stage, which amplifies the low-frequency measurement signal to the actual level of +/-40V.
Friendly greetings.
Is it possible to increase the output voltage of the RF outputs of the STEMlab board (e.g. STEMlab 125-14) from +/-1V (2V peak-to-peak) to +/-5V (10V peak-to-peak) by software ?
If not, would there be a circuitry measure that could be connected directly to the output to achieve this goal, e.g. a suitable amplifier add-on board that also has RF inputs and outputs with suitable SMA sockets ?
I need a symmetrical output voltage of +/-5V (full AC no DC) to supply an amplifier output stage, which amplifies the low-frequency measurement signal to the actual level of +/-40V.
Friendly greetings.