RF Output - Gibbs phenomenon ?

Placement, modules, components and accessories; the ones that exist and the the nice-to-be's
Post Reply
pmrp
Posts: 1
Joined: Thu Jun 10, 2021 8:57 am

RF Output - Gibbs phenomenon ?

Post by pmrp » Thu Jun 10, 2021 9:30 am

Hello Red Pitaya community !

I am just beginning to play with this wonderful tool (RP 125-14), mostly with basic RF signal generation & acquisition.

My project involve sending pulse-echo signals for ultrasound NDT applications. However, while playing with the oscilloscope app to generate 1us pulses (using 1kHz PWM with 0.1% duty cycle), I noticed a very high amplitude oscillations with a central frequency around 20MHz (see the screenshot below).

The setup is very simple: the OUT1 is directly plugged to the IN1 via a BNC cable & adaptors. All other inputs/ouputs are isolated with 50ohm terminators. Swapping between inputs and outputs does not change anything in the result.

Is it the usual behavior ? I would not expect the Gibbs phenomenon to be that strong, given the bandwidth of the RP's outputs. Would that come from the impedance of the BNC cable or something else ?

Image

Thank you by advance !

kasaudio
Posts: 49
Joined: Sun Mar 11, 2018 6:03 pm

Re: RF Output - Gibbs phenomenon ?

Post by kasaudio » Thu Jun 17, 2021 1:02 pm

Hello.

Is out1 also 50 ohm terminated?

User avatar
redpitaya
Site Admin
Posts: 539
Joined: Wed Mar 26, 2014 7:04 pm

Re: RF Output - Gibbs phenomenon ?

Post by redpitaya » Thu Aug 12, 2021 10:08 am

it is, and all the specs for all the boards are easily accessible, also for comparison reasons, here:
https://redpitaya.com/rtd-iframe/?ifram ... dware.html

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 1 guest