Diagnosing failure to connect to STEMlab 125-10

Placement, modules, components and accessories; the ones that exist and the the nice-to-be's
Post Reply
Eddy77
Posts: 4
Joined: Fri Nov 12, 2021 3:39 pm

Diagnosing failure to connect to STEMlab 125-10

Post by Eddy77 » Mon Nov 15, 2021 1:25 pm

Hello everybody out there using Red Pitaya,

I have two STEMlab 125-10, one of which I can connect to without problems and one to which I can't.
I tested the one which is not working with the SD card of the functional one to exclude software problems, but it still didn't work. Since also the direct connection with a ethernet cable doesn't work, it's unlikely a network problem.

Therefore it could be due to a hardware issue. I tried to make sense of the schematics on https://downloads.redpitaya.com/doc/Red ... 0_V1.0.pdf and carefully watched https://www.youtube.com/watch?v=9xZCAkXAkw8.

LED 10 ("Power Good") is lighting up in green and
LED 11 ("Prog Done") is lighting up in blue.
LED 9 is blinking in red.

What additional diagnostics could I run to pin down the problem?

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 5 guests