Hello,
Is it possible to measure a signal which is potentially between ±5V (Sensor output with integrated amplifier) with the ±1V input range. I want a higher resolution, and anything above 1V is not really of interest for my application. Just want to check that I do not damage the board.
Best regards
Maximilian
Can I safely overload LV mode [Stemlab 125-14 DK]
-
- Posts: 4
- Joined: Tue Jun 27, 2023 11:01 am
- redpitaya
- Site Admin
- Posts: 918
- Joined: Wed Mar 26, 2014 7:04 pm
Re: Can I safely overload LV mode [Stemlab 125-14 DK]
Hello Maximilian,
Thank you for contacting us through the forum.
The fast analog inputs can handle a maximum of +-30 V (this is the maximum the voltage protection can handle).
The board should not be damaged by the 5 V signal on LV jumper settings. However, we do not recommend using it outside the specified voltage ranges (LV +-1V, HV +-20V).
Thank you for contacting us through the forum.
The fast analog inputs can handle a maximum of +-30 V (this is the maximum the voltage protection can handle).
The board should not be damaged by the 5 V signal on LV jumper settings. However, we do not recommend using it outside the specified voltage ranges (LV +-1V, HV +-20V).
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 4 guests