Cannot connect to Red Pitaya

Placement, modules, components and accessories; the ones that exist and the the nice-to-be's
Post Reply
jean baptiste
Posts: 1
Joined: Thu Oct 02, 2014 10:26 am

Cannot connect to Red Pitaya

Post by jean baptiste » Thu Oct 02, 2014 10:39 am

Hello to all,

I have a problem with my new red pitaya board: I cannot connect via the web browser.
So I have downloaded the image, I have inserted it into the slot, I have connected the board to the network and it has an IP.
However, when I tap the address into the browser, it does not communicate with the board.

What should I do? Can I connect to the board via USB and Matlab?

Best regards,
Jean

Nils Roos
Posts: 1441
Joined: Sat Jun 07, 2014 12:49 pm
Location: Königswinter

Re: Cannot connect to Red Pitaya

Post by Nils Roos » Wed Oct 08, 2014 6:15 pm

You can plug a USB cable into the CONsole port, it should register as new a serial port on your computer. Then open a shell on the RP via the new port (eg. with PuTTY, choose connection type "Serial", speed 115200).

From there you can test whether nginx is running, if the network link is up and configured correctly, etc.
You can also "reboot" the RP and have a look at the messages during boot.

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 23 guests