Hello to all,
I have a problem with my new red pitaya board: I cannot connect via the web browser.
So I have downloaded the image, I have inserted it into the slot, I have connected the board to the network and it has an IP.
However, when I tap the address into the browser, it does not communicate with the board.
What should I do? Can I connect to the board via USB and Matlab?
Best regards,
Jean
Cannot connect to Red Pitaya
-
- Posts: 1441
- Joined: Sat Jun 07, 2014 12:49 pm
- Location: Königswinter
Re: Cannot connect to Red Pitaya
You can plug a USB cable into the CONsole port, it should register as new a serial port on your computer. Then open a shell on the RP via the new port (eg. with PuTTY, choose connection type "Serial", speed 115200).
From there you can test whether nginx is running, if the network link is up and configured correctly, etc.
You can also "reboot" the RP and have a look at the messages during boot.
From there you can test whether nginx is running, if the network link is up and configured correctly, etc.
You can also "reboot" the RP and have a look at the messages during boot.
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 100 guests