I'm trying to connect two Red Pitayas via daisy chain connector. I couldn't find any avaliable docs so I'm trying to figure something out experimentally.
Daisy chain connector of Pitaya 1 (lower) is connected to other Pitaya connector (higher) by SATA II cable. I suppose first connector is Tx and second is Rx because other way it doesn't work at all. So, I type
Code: Select all
monitor 0x40500000 0x3
on both Pitayas (ssh) to enable transmitters and receivers. After that, I set up transmitter:
Code: Select all
monitor 0x40500004 0x12340002
Code: Select all
monitor 0x4050000C
Code: Select all
0x00002341
Is there any way to get it work correctly and more reliable?
Alex.