Driving 50 ohms with 5V pulses

Placement, modules, components and accessories; the ones that exist and the the nice-to-be's
Post Reply
VOLA
Posts: 1
Joined: Wed Jun 25, 2014 10:35 am

Driving 50 ohms with 5V pulses

Post by VOLA » Tue Jun 09, 2015 9:00 am

Hello,

I want to use the function generator possibility of Red Pitaya in order to deliver 5V pulses (~10µs/low frequency).
The output of RedPitaya is +/-1V or best for me 0-1V, but too low for my application.
I know how to translate the output level to 5V (with a comparator MAX903 and with the 5V power supply of the Red Pitaya).
I have an other problem : I want to trigger an high voltage pulse generator with 50 ohm input and which need 5V +/-1V input pulse signal.
I want again to use the 5V power supply I can get from the RedPitaya.
Is there a simple solution (I think of paralleling a MOSFET driver like ICL7667), could you give me some advices ?

Sincerely

timmolter
Posts: 5
Joined: Thu Jun 23, 2016 2:55 pm

Re: Driving 50 ohms with 5V pulses

Post by timmolter » Mon Jul 04, 2016 11:39 am

I'm curious about this too. Anyone knowledgable on this topic want to share ideas?

brussieux
Posts: 1
Joined: Mon Sep 29, 2014 2:47 pm

Re: Driving 50 ohms with 5V pulses

Post by brussieux » Tue Nov 15, 2016 4:54 pm

...same problem : i'd like to interface Red Pitaya analog outputs 1 and 2 to trigger standard 3,3V logic. One volt is'nt enough for TTL inputs...

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 2 guests