Hi,
I have a similar problem when i try to synchronize generation and acquisition. Steve have you solved your problem?
Synchronization of generate and acquire
-
- Posts: 29
- Joined: Thu Nov 27, 2014 5:21 am
Re: Synchronization of generate and acquire
I have also similar problem...can anybody help me??
-
- Posts: 1441
- Joined: Sat Jun 07, 2014 12:49 pm
- Location: Königswinter
Re: Synchronization of generate and acquire
Hi all,
I just had a look over Steve's approach, and there were several issues with it:
Cheers
Nils
I just had a look over Steve's approach, and there were several issues with it:
- wrong decimation value, it is either 1024 or 0x400, 0x1024 is not a supported decimation
- the trigger pointer needs to be multiplied by 4 to convert it to a buffer address, so in his example the address to read from would have been 0x4011b650 (0x40110000 + 4*0x2d94)
Cheers
Nils
-
- Posts: 29
- Joined: Thu Nov 27, 2014 5:21 am
Re: Synchronization of generate and acquire
hii... i amnew to redpitaya....i am following the codes given above... and referring the FPGA register map for information... but i am not getting the right way... i want data which will be acquired after trigger is applied... when trigger pulse is not given or at low no data should be acquired....can anybody tell me the setup of hardware and code which is to be run on putty...??
-
- Posts: 34
- Joined: Wed Jun 25, 2014 11:38 pm
Re: Synchronization of generate and acquire
Since I started this thread, I think I will comment on what success I had... or not
Well, I was not able to synchronize generate and acquire as hoped. I solved the synchronization issue by some other skullduggery within LabVIEW code (ugh!), and was able to properly generate Bode magnitude and phase plots, and a Nyquist plot, of our test circuits.
That was our goal all along, not to make a proper RP App of this but to have functionality for use with LabVIEW.
tot ziens
Well, I was not able to synchronize generate and acquire as hoped. I solved the synchronization issue by some other skullduggery within LabVIEW code (ugh!), and was able to properly generate Bode magnitude and phase plots, and a Nyquist plot, of our test circuits.
That was our goal all along, not to make a proper RP App of this but to have functionality for use with LabVIEW.
tot ziens
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 90 guests