Hi VNA experts,
I did my first steps with Pavel's VNA software . With a bridge bought at eBay it seems to work fine.
After calibration with OPEN-key and SHORT-key the Impedance diagramm shows what is expected for the DUT.
What I do not understand is the function of the key load. It seems that it's flats the curve on the load/ref input to 50 Ohms??? (I have 50 ohms attached there.)
Could you please give me a hint what that key does. Or has somebody a manual where I can read about. Searching for that was'nt successful.
Dieter
VNA LOAD-Key
-
- Posts: 799
- Joined: Sat May 23, 2015 5:22 pm
Re: VNA LOAD-Key
Hi Dieter,
The LOAD calibration should be done with a 50 Ohm load. The results of this calibration are used for the impedance calculation. Here is a link to the corresponding code:
https://github.com/pavel-demin/red-pita ... na.py#L701
Best regards,
Pavel
The LOAD calibration should be done with a 50 Ohm load. The results of this calibration are used for the impedance calculation. Here is a link to the corresponding code:
https://github.com/pavel-demin/red-pita ... na.py#L701
Best regards,
Pavel
-
- Posts: 7
- Joined: Wed Jan 10, 2018 9:42 am
Re: VNA LOAD-Key
Hi Pavel
many thx for the quick answer.
So, I did it correct and will deepen into the code.
And it's a great app you developped.
Dieter
many thx for the quick answer.
So, I did it correct and will deepen into the code.
And it's a great app you developped.
Dieter
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 59 guests