Board schematics for version 1.2.x

Just about everything about Red Pitaya
Post Reply
jsgl234
Posts: 1
Joined: Tue Dec 18, 2018 3:38 pm

Board schematics for version 1.2.x

Post by jsgl234 » Tue Dec 18, 2018 3:44 pm

Hi everyone,

I'm currently seeing different behaviour between a version 1.0 RP and a version 1.2.14 RP when powering it using the pins (behaviour is as expected when powering using USB). There is obviously something wrong with the voltages we're providing it with but I'd like to see what the hardware differences are between the boards. Is it possible to get schematics of the newer board versions, as you could with version 1.0?

Many thanks for any help.

Kilroy
Posts: 29
Joined: Thu Feb 19, 2015 11:03 am
Location: Moenchengladbach, Germany
Contact:

Re: Board schematics for version 1.2.x

Post by Kilroy » Wed Dec 19, 2018 9:03 am

What kind of difference do you observe?
The only voltage needed is a +5V on expansion connector E2 pin 1 and the GND connected to pin 21/22. Works fine here without problems.
All other voltages on the expansion connectors are output voltages.
Regards
Uwe

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 24 guests