Hi,
When I connect the analog output of Red Pitaya STEMLAB 125-14 to the analog input of the same device (loopback), using a BNC cable (no probe), I get the following ( HV, 2KHz, 2 Volts peak to peak) :see 2nd picture
In // I connect the output of Red Pitaya (STEM 125-14) to my oscilloscope (Hantek 4102C) with the following result : see 1st picture
It seems obvious the the input stage of Red Pitaya is overshooting. I went through the forum and found a previous thread named "Input Stage Inerfections" but I didn't see a clear and usable fix for this problem.
I do not use any probe, only straight 50 ohms cables with BNC connections. I try to load the output with a 50 ohms load without any change (obvious).
The unit is a new one delivered in 2019. It replaces a previous unit that didn't show the same issue (as far as I remenber).
Please help
cgo75
Input stage overshoot
-
- Posts: 1
- Joined: Mon Sep 21, 2015 3:18 pm
Input stage overshoot
You do not have the required permissions to view the files attached to this post.
- redpitaya
- Site Admin
- Posts: 901
- Joined: Wed Mar 26, 2014 7:04 pm
Re: Input stage overshoot
And what happens if instead of the regular cables that you used on Red Pitaya, you are making the connection with the hantek probe cable?
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 28 guests