Hi,
I want to feed a clock out of the RedPitaya via the sata connector S1 connector. The two clock pins of S1 are connected by a 100Ohms resistor (for differential clock output). However, since I want to have a single-ended output I would like to remove this resistor (R43 in the schematics). Unfortunately, it isn't depicted in the schematics file. Does anyone got an idea how to find it?
Remove R43 to have a single-ended clock output
- redpitaya
- Site Admin
- Posts: 907
- Joined: Wed Mar 26, 2014 7:04 pm
Re: Remove R43 to have a single-ended clock output
Hi,
it is on the bottom side of the board - see attached photo.
kind regards, Red Pitaya team
it is on the bottom side of the board - see attached photo.
kind regards, Red Pitaya team
You do not have the required permissions to view the files attached to this post.
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 41 guests