Lantiq PHY in config in Petalinux

Just about everything about Red Pitaya
Post Reply
Posts: 2
Joined: Tue Feb 19, 2019 9:46 am

Lantiq PHY in config in Petalinux

Post by motagiyash » Mon Jan 13, 2020 11:10 am

Hello experts,

I am working with petalinux and i am trying to figure out how do i set the skews of this board.

I am not able to ping or ,run the UDP code i wrote.

Posts: 639
Joined: Sat May 23, 2015 5:22 pm

Re: Lantiq PHY in config in Petalinux

Post by pavel » Wed Jan 15, 2020 1:26 pm

I think the INTEL_XWAY_PHY driver should work even with the default skew values. If the board can't be pinged, then it seems that the PHY driver isn't running. Have you checked that the Linux kernel you're using has the INTEL_XWAY_PHY driver?

More information about the time skew values can be found at this link.

In the PHY driver patched by the Red Pitaya developers, the RX and TX time skews were set to 2 ns and 2.5 ns: ... tiq.c#L344

Here is a link to my patch for the INTEL_XWAY_PHY driver in Linux 4.19: ... ch#L26-L68

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 1 guest