Change the FPGA fast analog output default voltage from -1V to -2V

Just about everything about Red Pitaya
Post Reply
alexthegalax
Posts: 6
Joined: Mon Sep 26, 2016 3:54 pm

Change the FPGA fast analog output default voltage from -1V to -2V

Post by alexthegalax » Tue Dec 19, 2017 12:31 pm

Hello Guys,

I am currently working to drive a half bride with the Red Pitaya’s high frequency output. The MOSFET requires at least 1.8V for an active high and so I desolder the bias resistors to get the whole analog output range of 0-2V. Unfortunately, I forgot, that the FPGA produces always -1V as default voltage to achieve 0V (-1V FPGA+1V BIAS) at the analog output, when it is not driven. I tried to find out where default voltage is defined in the FPGA image files, but without any luck.

Does anybody know, how I can change the FPGA default analog output voltage from -1V to -2V? Or any other suggestions how to tackle this problem?

My aim is achieve again 0V when the fast analog output is not driven.
Thanks in advance!
Alex

majtom
Posts: 9
Joined: Thu Nov 08, 2018 10:29 am

Re: Change the FPGA fast analog output default voltage from -1V to -2V

Post by majtom » Tue Dec 04, 2018 10:58 am

Hi Alex,

Did you solve this?
I have the same issue.

- Maja

Post Reply
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie

Who is online

Users browsing this forum: No registered users and 3 guests