I'm trying to do some power supply stability measurement with RP and I can't get satisfying results.
I'm trying to measure a cheap DC/DC converter with LM2596. I basically follow the Bode100 app note. As an injection transformer, I used a 3VA transformer with two separate 9V secondary windings. One is connected to the output of RP (DC resistance ~25Ohm) and another is connected to 10Ohm resistor in the feedback loop.
https://www.omicron-lab.com/fileadmin/a ... y_V3_3.pdf
However, the measurement is somewhat distorted and the output is not expected.
I wasn't able to find more information on this subject with RP integration.
Is it possible to get more information on how to correctly use RP in this case?
Also, the measurement is relatively slow.
Just about everything about Red Pitaya
1 post • Page 1 of 1
- Posts: 1
- Joined: Fri Jul 03, 2020 1:23 pm
You do not have the required permissions to view the files attached to this post.
jadalnie klasyczne ekskluzywne meble wypoczynkowe do salonu ekskluzywne meble tapicerowane ekskluzywne meble do sypialni ekskluzywne meble włoskie
Who is online
Users browsing this forum: No registered users and 4 guests